Marantec 122436 2-Channel Remote Control 916MHz
Open your garage doors with Marantec’s 2-Channel Remote Control. Operating on the HomeLink compatible frequency of 315 MHz, the remote control can be clipped onto the visor in your car or attached to a keychain. Extremely secure multi-bit code technology allows you to program an unlimited amount of Marantec remote controls as well as vehicles.
- 2-Channel remote control can operate up to two Marantec garage door operators or other Marantec external devices
- 916MHz operating frequency is HomeLink compatible
- Extremely secure multi-bit code technology allows for a limitless amount of Marantec remote controls as well as vehicles to be programmed
- Compatible only with Marantec garage door openers with the operating frequency of 916MHz
- Includes a long-lasting 3-volt lithium battery
- 1-year limited parts warranty
- Remotes includes a visor clip for your car
- Programming Instructions
- Programming Connector
The most important aspect when ordering wireless accessories for your Marantec garage door operator is the operating frequency. For many years, the main radio frequency for Marantec systems has been 315MHz. Following are a few steps that will help you in determining the correct accessory for your garage door operator:
- If you own a Synergy 260, 270, 280, 360, 370, 380, an M55 or a Solo operator with frequency 916MHz.
For other units, please refer to your original manual on the accessories page to find listings of remotes that go with your unit. If you do not have the original, you can check the modular receiver to find the frequency (MHz). You will need a ladder and a flashlight. This is on top of the motor and it has a light grey antenna wire coming out of it. It will list the MHz number on it. However, if it is not the 916MHz or if the antenna wire goes into a hole of the powerhead, then it is an older frequency and would need an external receiver. If you find the manufacture date on the power head of 2004 or newer, then it is the 916MHz frequency. Or please provide the serial number located on the side of the power head at the ceiling. It will usually be on a white sticker, it will say "Serial #", and typically 7-10 digits-no letters or it may be a bar code number. We would be happy to look it up for you and recommend the correct transmitter.